Ratoc Systems USB-Serial Converter REX-USB60 Manual de instrucciones descargar pdf (Pagina 3)

SAFETY PRECAUTIONS

The AC Servo Drive Setup Software is used to connect the Hitachi AC Servo Drive AD Series to

a personal computer. It does not operate independently. When operating a servo drive,

thoroughly read its instruction manual as well as this instruction manual for safety assurance.

The safety precautions set forth in this instruction manual are classified into the WARNING and

CAUTION categories.

: Indicates that a hazardous situation may arise to cause death or

serious injury if the correct handling procedure is not followed.

: Indicates that a hazardous situation may arise to cause moderate or

minor injury or incur property damage only if the correct handling

procedure is not followed.

If the instructions set forth under NOTE are ignored, serious consequences may result

depending on the situation.

The instructions and precautions set forth under the above categories are all important and

must be observed at all times.

After this instruction manual is read, it must be stored at a predetermined place so that the user

of the software can readily refer to it at any time.

Q Wiring precautions

CAUTION

1. When disconnecting or connecting the communication cable, be sure that the servo drive

and personal computer are both turned off. If you disconnect or connect the

communication cable while the power is on, the servo drive and personal computer may

become defective.

2. While the AC Servo Drive Setup Software is running, never disconnect or connect the

communication cable. When the communication cable is reconnected, be sure to exit the

software and restart. If you do not restart the software, the software and servo drive may

malfunction.

Q Usage precautions

CAUTION

1. When the servo drive control power is turned off, be sure to exit the AC Servo Drive Setup

Software and restart. If you turn on the servo drive control power without exiting the

software, the software and servo drive may malfunction.

2. Do not turn off the servo drive control power while the initialization or parameter rewrite

process is in progress. If the servo drive control power turns off during a write, the

EEPROM data in the servo drive may become damaged, causing the servo drive to

improperly operate.

WARNING

CAUTION

1 2 3 4 5 6 7 8 ... 77 78

Sin comentarios

Ratoc Systems USB-Serial Converter REX-USB60 Manual de instrucciones Pagina 3